Printable Version of Topic

Posted by: Dominator Jul 26 2008, 13:10

Hi,
I have created a small island following various tutorials, mainly Allie's. But when it comes to packing it all up to a pbo there is not much guidence out there. I need help,

I have inside mymap folder-
the data folder- with paa's and rvmat's, layer folder with paa's and rvmats
mymap.wrp
mymap.hpp
config.cpp

I pack it with BinPBO not binarized
put it in my addons folder

I get the error message-
No entry "bin\config.bin/CfgWorlds.mymap"
Thanks.

Posted by: MODUL Jul 26 2008, 22:40

Looking at the message on an error, i can assume that you have an error in config.cpp.
Check up attentively config.cpp, pay attention to a word "mymap", you are probable have not specified it or there where it should be, there is something another.

Posted by: Dominator Jul 27 2008, 10:08

Thanks,
I did miss replacing one of the mymaps.
now I have another problem- when the map loads I get a error message-

Cannot load material file ca\mymap\data\layers\p_000-000_L00.rvmat.

I can play on the island but there are no textures
The file p_000-000_L00.rvmat. does exist and is in the pbo
The .rvmat's, .paa's, config.cpp, and mymap.wrp are not binarized, do they have to be?, if so how?

I appriciate your help as I have scoured the net to try to find thes answers and nothing is black and white.

Posted by: MODUL Jul 27 2008, 13:15

I made island only for OFP and it was for a long time, therefore i not so good assistant to you...

Check up names of layers in layers.cfg.
And for increase of knowledge and reduction of amount of questions http://community.bistudio.com/wiki/Visitor_3:_Making_of_simple_landscape.

Posted by: Dominator Jul 27 2008, 14:09

Thanks, this is what ive been after, I think I know what is wrong. Its a lot of trail and error and Im only new to this.

Posted by: Sovietzug Dec 20 2010, 03:09

I'm with the same problem

I dedicated so many time to try resolve it but i cannot.

I checked names, directories, cfg, etc and all seems correct.